Intermediate milling set

The Intermediate Milling Set includes the following equipment:

  • 1x 3.175 mm (1/8 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, square end
  • 1x 3.175 mm (1/8 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, ball end
  • 1x 4.763 mm (3/16 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, square end
  • 1x 4.763 mm (3/16 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, ball end
  • 1x 6.35 mm (1/4 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, square end
  • 1x 6.35 mm (1/4 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, ball end
  • 1x 9.53 mm (3/8 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, square end
  • 2x 9.53 mm (3/8 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, ball end
  • 1x 12.7 mm (1/2 in) end mill, 9.525 mm (3/8 in) shank, 2 flutes, square end
  • A hold-down set of clamping accessories to clamp the vise or part on the mill table
  • An edge finder: single 9.53 mm (3/8 in) shank, 5.08 mm diameter (0.2 in) head
  • 6x R8 end mill holders for 9.53 mm (3/8 in) shank end mills
  • A R8 collet for 9.53 mm (3/8 in) shank end mills
  • A t-slot cleaner