EV Simulator/Tester

EV Simulator/Tester


The EV Simulator/Tester consists of a commercial EVSE adapter used for verification of electrical safety and functional testing of charging stations in accordance with industry regulations. The unit connects directly into a Mennekes output on the Electric Vehicle Charge Controller.

Using the controls, the adapter will enable the user to test different cable current capacities and test various electric vehicles charging statuses.


  • Safety socket outputs for connection to a 3-phase installation tester
  • Voltage indicators on EVSE output
  • Proximity Pilot resistance selector for simulation of EV cable presence and current rating detection
  • Control Pilot resistance selector for simulation of electric vehicles status
  • Socket output for connection to a 1-phase installation tester
  • Type 2 Male Plug connector for connection to EVSE
  • 6 mA EV RCD support
  • Load testing up to 13 A on sockets
  • Fault simulation of Diode short, PE-CP short and PE open


  • Input voltage: 400 V AC (3-phase), 50 Hz  
  • Maximum load current: 13 A (continuous)
  • Proximity Pilot (PP) simulation: Open circuit, 13 A, 20 A, 32 A, 63 A
  • Control Pilot (CP) simulation
    – State A (not connected)
    – State B (connected, not charging)
    – State C (charging without ventilation)
    – State D (charging with ventilation)
  • Error states: CP short to PE via diode, Diode short, PE open
  • Test lead length: 0.5 m
  • Dimensions (L x W x H): 250 x 100 x 70 mm
  • Weight : 0.9 kg