EduTrainer supply unit

EduTrainer supply unit

The supply unit ensures safe operation of single-phase servo controllers or frequency converters at workstations where there is no corresponding infrastructure. It is connected to the mains supply via a non-heating device cable and makes it possible to provide an electrically safe workstation even in places where there is no separate fuse protection or type B RCD protection available.

The unit offers the following functions:

  • Short circuit protection
  • RCD protection, type B
  • Circuit breaker B10
  • Emergency stop for the workstation
  • Safety when restarting after voltage recovery
  • Switching the workstation power supply on and off

It also provides the 24 V DC voltage necessary for operation.

The locations of all connections are standardised and are laid out as safety sockets.

Technical data

  • Supply voltage: 1 AC/230 V (50 Hz)
  • Output voltage: 1 AC 230 V with type B RCD protection 30 mA, output current max. 10 A
  • DC 24 V, 2 A
  • All outputs protected against short circuits and overload
  • Front panel: 133 x 297 mm
  • Console housing with rubber feet for use in an A4 frame or on a table
  • Power supply via non-heating device connection
  • Phase monitoring for polarity reversal and failure
  • Lockable on/off switch
  • Outputs for 4 mm safety plugs

 

 

Telefono
02.457.94.289