FluidLab®-M Single license

FluidLab®-M Single license

Software for freely configurable data acquisition, visualisation and storage of analogue measured values from fluid engineering equipment and systems through the use of common industrial sensors with voltage output signal. Any desired sensors with voltage output can be set up and adapted with just a few simple steps. The measuring sequence can be controlled externally, as well as manually with the software, or it can be programmed as a sequencing program within the software. Recording and processing of up to 4 analogue inputs, 2 analogue outputs, 4 digital inputs and 4 digital outputs is possible. Results can be saved and compared with other measurements. Data can also be exported to a spread sheet programme. Either (de/en) can be selected for the software.

System requirements

    • PC with Windows XP/7/8
    • Pentium® III or equivalently
    • 2 GB RAM
    • CD-ROM disk drive
    • USB 2.0 or serial interface
    • 1280 x 1024 pixels
    • NI LabView 2012 Runtime (included in scope of delivery)

 

 

Customer Service Line:
Deutschland +49/(0)711/3467-0